Enke Concrete Primer is a solvent- and plasticiser-free, single component acrylic-based polymer dispersion. It is primarily used as a bonding primer on mineral substrates such as concrete and cement screed, as well as on weathered bituminous membranes, where a soivent free system is required.

The concrete primer is ideal when:

• work is being carried out indoors or in sensitive environments,
• solvents must not be used,
• mineral substrates require a uniform bonding layer.

It is the right alternative to solvent-based Primers when environmental and occupational safety are the main priorities.

Apply using a lambskin roller or a brush.
The drying time is approximately 1–3 hours, depending on the temperature and the absorbency of the substrate. There is no fixed interval for re-coating – the surface can be recoated at a later date without any problems.

Consumption is approximately 200–400 g/m², depending on:

• the porosity of the substrate
• Surface texture

The aim is to achieve an even, continuous film without any gaps. Applying the product too thinly may impair adhesion, whilst applying it too thickly will prolong the drying time.

Enke Concrete Primer is not subject to labelling requirements and is not classified as hazardous under the CLP Regulation.

Important:

• protect from frost
• Store containers tightly sealed
• Avoid discharge into the sewerage system or watercourses

The instructions in the safety data sheet must be followed.